To install your new Hood you will need a drill with a 5/16 drill bit and a 1/4 inch drill bit.

1st remove your stock hood, (save the 2 plastic push pins up top)

drill 2 holes, as shown on both sides of the fenders.

Thread a zip tie through the holes. Do this to pull the fenders in closer together.

This step needs to be done on most machines but not all of them. Doing this will ensure there is no gap from the hood the fenders once completely installed.

If you do not have a zip tie long enough, you can join 2 together as shown.

The next step is to install the hood ON TOP only. Using the 2 stock plastic push pins.

After installing the top 2 push pins....line up the bottom and mark your fenders through the pre-drilled holes in the hood.

Mark both sides , This is also a good time to check and make sure there is no gaps on the sides, if there is you can tighten your zip tie.

Now remove the hood and drill your fenders with the 5/16 drill bit as shown below.

LIKE THIS (this hole does NOT go through to the outside) only drill through the 1st layer!!!

Now reinstall your hood and insert the supplied push pins fron the inside out as shown.

It should look something like this.